Air pollutant concentrations near three Texas roadways,Part I: Ultrafine particles

Vehicular emitted air pollutant concentrations were studied near three types of roadways in Austin, Texas: (1) State Highway 71 (SH-71), a heavily traveled arterial highway dominated by passenger vehicles; (2) Interstate 35 (I-35), a limited access highway north of Austin in Georgetown; and (3) Farm to Market Road 973 (FM-973), a heavily traveled surface roadway dominated by truck traffic. Air pollutants examined include carbon monoxide (CO), oxides of nitrogen (NO_x), and carbonyl species in the gas-phase. In the particle phase, ultrafine particle (UFP) concentrations (diameter < 100 nm), fine particulate matter (PM_2.5, diameter < 2.5 μm) mass and carbon content and several particle-bound organics were examined. All roadways had an upwind stationary sampling location, one or two fixed downwind sample locations and a mobile monitoring platform that characterized pollutant concentrations fall-off with increased distance from the roadways. Data reported in this paper focus on UFP while other pollutants and near-roadway chemical processes are examined in a companion paper. Traffic volume, especially heavy-duty traffic, wind speed, and proximity to the road were found to be the most important factors determining UFP concentrations near the roadways. Since wind directions were not consistent during the sampling periods, distances along wind trajectories from the roadway to the sampling points were used to study the decay characteristics of UFPs. Under perpendicular wind conditions, for all studied roadway types, particle number concentrations increased dramatically moving from the upwind side to the downwind side. The elevated particle number concentrations decay exponentially with increasing distances from the roadway with sharp concentration gradients observed within 100–150 m, similar to previously reported studies. A single exponential decay curve was found to fit the data collected from all three roadways very well under perpendicular wind conditions. No consistent pattern was observed for UFPs under parallel wind conditions. However, regardless of wind conditions, particle concentrations returned to background levels within a few hundred meters of the roadway. Within measured UFP size ranges, smaller particles (6–25 nm) decayed faster than larger ones (100–300 nm). Similar decay rates were observed among UFP number, surface, and volume.     

An Edge Effect Caused by Adult Corn-Rootworm Beetles on Sunflowers in Tallgrass Prairie Remnants

Abstract: The once-extensive tallgrass prairie community of North America has been reduced to small remnants, many of which are surrounded by intensive corn (   Zea mays ) agriculture. We investigated adult corn-rootworm beetles (Chrysomelidae : Diabrotica spp.), important pests of corn, on sunflowers (Asteraceae : Helianthus spp . ) in prairie remnants in southeast Minnesota. Large numbers of beetles invaded the prairie from surrounding corn fields in late summer. D. barberi and D. virgifera were captured on sticky traps in all locations in the prairie, but abundance was much greater near the edge adjacent to corn. We observed D. barberi ( but not D. virgifera ) feeding extensively on sunflower pollen and occasionally on other flower parts, such as petals. Sunflowers located nearer corn fields sustained more floral damage than those farther from corn. To determine the effect of beetle damage on seed set, we enclosed sunflower heads in bags with either zero, two, or four D. barberi adults. Seed set was reduced in heads enclosed with D. barberi . Thus, this agricultural pest may interfere with the successful reproduction of sunflowers and possibly other prairie composites that flower in late summer. Given the small size of most prairie remnants and the abundance of this flower-feeding beetle in landscapes dominated by corn agriculture, D. barberi may affect the sustainability of prairie plant populations.     

Fuel Oil Additives for Controlling Air Contaminant Emissions

An addition of additives to fuel oils prior to combustion is one way of reducing combustible contaminant emissions to the outer air. Reported test results show that some additives improve, moderately, the combustive properties of fuel oils. Combustion is also improved but to a lesser degree, in boiler systems that are deficient in operation and design. Being combustible, polynuclear hydrocarbons emissions would be reduced by use of additives. Other types of additives to reduce slagging and inhibit corrosion from combustion of fuel oils are also available. The cost of using additives is low. Improved additives are required, especially ones to better combustion in the deficient boiler systems. These can be found by research and literature surveys. Their effectiveness and nontoxicity would be confirmed by laboratory and field testing.     

Recovering CO2 From Large− and Medium-Size Stationary Combustors

This paper summarizes the results of research conducted at Ar-gonne National Laboratory (ANL) to develop and design a novel method for the recovery of CO₂ from flue gases. The basic process concept Involves the combustion of a hydrocarbon fuel using a mixture of oxygen and carbon dioxide (or CO₂ and H₂0) rather than air as the oxidant, which results In a product stream that contains primarily CO₂ and H₂O. This stream Is then dried and conditioned to meet the specifications of the end user, A slip stream of CO₂ (or CO₂, and H₂0) is used as a diluent in the combustion chamberto maintain a flame temperature equivalent to the temperature that would otherwise be obtained using air as an oxidant. The cost-effectiveness of the process in recovering C0₂ is dependent on the scale of the operation, the type of fuel used, the cost of oxygen, and the cost of capital. The sensitivity of the cost of the recovered C0₂ to these variables Is discussed, and a model for estimating the cost of CO₂ recovered using the ANL process Is presented.     

Contamination of nonylphenolic compounds in creek water, wastewater treatment plant effluents, and sediments from Lake Shihwa and vicinity, Korea: comparison with fecal pollution

Nonylphenolic compounds (NPs), coprostanol (COP), and cholestanol, major contaminants in industrial and domestic wastewaters, were analyzed in creek water, wastewater treatment plant (WWTP) effluent, and sediment samples from artificial Lake Shihwa and its vicinity, one of the most industrialized regions in Korea. We also determined mass discharge of NPs and COP, a fecal sterol, into the lake, to understand the linkage between discharge and sediment contamination. Total NP (the sum of nonylphenol, and nonylphenol mono- and di-ethoxylates) were 0.32-875 μg L⁻¹ in creeks, 0.61-87.0 μg L⁻¹ in WWTP effluents, and 29.3-230 μg g⁻¹ TOC in sediments. Concentrations of COP were 0.09-19.0 μg L⁻¹ in creeks, 0.11-44.0 μg L⁻¹ in WWTP effluents, and 2.51-438 μg g⁻¹ TOC in sediments. The spatial distributions of NPs in creeks and sediments from the inshore region were different from those of COP, suggesting that Lake Shihwa contamination patterns from industrial effluents differ from those from domestic effluents. The mass discharge from the combined outfall of the WWTPs, located in the offshore region, was 2.27 kg d⁻¹ for NPs and 1.00 kg d⁻¹ for COP, accounting for 91% and 95% of the total discharge into Lake Shihwa, respectively. The highest concentrations of NPs and COP in sediments were found in samples at sites near the submarine outfall of the WWTPs, indicating that the submarine outfall is an important point source of wastewater pollution in Lake Shihwa.     

A Movable Laboratory for Controlled Clinical Studies of Air Pollution Exposure

The cause of the Yokkaichi asthma episode (1960-1969) has been analyzed. It Is concluded that the respiratory diseases were due not to sulfur dioxide but to concentrated sulfuric acid mists emitted from stacks of calciners of a titanium oxide manufacturing plant located windward of the residential area.     

Hormesis and plant biology

A database has been developed that demonstrates experimental evidence of hormesis. It includes information from a broad range of biological models, including plants, and information on study design, dose-response features, and physical/chemical properties of the agents. An assessment of plant hormetic dose responses is presented based on greater than 3000 plant endpoints. Plant hormetic dose responses were observed for numerous endpoints including disease incidence, reproductive indices, mutagenic endpoints, various metabolic parameters, developmental processes, and a range of growth indicators. Quantitative features of these dose responses typically display a maximum stimulatory response less than two-fold greater than controls and a width of the stimulatory response usually less than 10-fold in dose range. The database establishes that hormetic dose responses commonly occur in plants, are broadly generalizable, and have quantitative features similar to hormetic dose responses found for animals.